Switch Side Support Installation

Switch Support Setup Instructions

Here, you will find the detailed Switch Support Instructions, designed to assist you in setting up and maintaining the versatile Switch Conversion System. This system includes multifunctional components like a bed, bulkhead, and storage drawer, offering a customisable solution for both work and leisure. Follow these instructions to ensure seamless installation and optimal performance, making your van conversion as efficient and adaptable as possible.

DOWNLOAD INSTRUCTIONS HERE

INCLUDED IN KIT

2 x M6 50mm bolts

2 x Switch Supports

TOOLS REQUIRED

5.5mm diameter drill bit H4 hex bit

Handheld drill

POSITION

Above wheel arch on the middle section of side M panels of the Ovano Switch.

1. Measure and mark 23cm from the unit’s base on the front of the middle arch on both sides of your Ovano Switch. (This is positioned next to the rear of your wheel arches.)
2. Using a 5.5mm drill piece, drill a 50mm hole into the front of the middle arch.
3. Position the side support adjustable slot over the hole in the Switch and align it with your wheel arch. Then secure the 50mm screw using your drill.
4. Now that your side supports are in place enjoy a rattle-free, secure unit! Your Switch legs can be stowed in the slot shown when not used.